2.1 KiB
Executable File
2018.01.25
Hack-a-day offered a project [https://hackaday.com/2017/12/26/fast-3d-printing-with-raspberry-pi-but-not-how-you-think/, Fast 3D Printing with Raspberry Pi ??? But Not How You Think]. However, it describes how to do stuff via OctoPi (child of OctoPrint), which we don't want to use. This led to the question "Any way to divorce Klipper from Octo*?" and also "Klipper as daemon"
Installation
Most of our machines use the Atmega AVR 2560 Rambo board. But we'll start with the Aden rebuild which uses the Atmega AVR 644p. Both are 16 MHz. So, select the proper microprocessor and speed in the menuconfig step below.
$ make menuconfig
$ make
Build Kconfig config file
Creating symbolic link out/board
Compiling out/src/sched.o
Compiling out/src/command.o
Compiling out/src/basecmd.o
Compiling out/src/debugcmds.o
Compiling out/src/gpiocmds.o
Compiling out/src/stepper.o
Compiling out/src/endstop.o
Compiling out/src/adccmds.o
Compiling out/src/spicmds.o
Compiling out/src/pwmcmds.o
Compiling out/src/avr/main.o
Compiling out/src/avr/timer.o
Compiling out/src/avr/gpio.o
Compiling out/src/avr/watchdog.o
Compiling out/src/avr/serial.o
Building out/compile_time_request.o
Version: v0.5.0-108-g1b3ef8a-20180125_195156-hostname
Linking out/klipper.elf
Creating hex file out/klipper.elf.hex
It has been suggested that socat may help debug stuff...
$ sudo apt install socat